Installation Guide & Hardware for Milwaukee Quick Release Bench Vises

The Installation Guide and Hardware Kit for Milwaukee 7" and 10" Quick Release Bench Vises includes a detailed instructional pamphlet and the hardware needed to install the vise in a typical configuration, attach a riser block if your bench top is less than 2 1/4" thick, and affix a pair of jaw liners.

The vise is attached to the bench using a couple of lag bolts from underneath and a few wood screws from the rear jaw into the bench. Oh, and we also include an extra couple cotter pins so you don't have to save the bent one you pull out to install the vise.

The hardware includes:
(2) Zinc-plated Steel Machine Screws, Pan Head, Slotted, 1/4"-20 Thread, 3/4" Length
(4) Zinc-plated Steel Screws, Flat head, Phillips, No 10 Size, 5/8" Length
(2) Zinc-plated Steel Lag Bolts, 3/8" Diameter, 2-1/2" Length
(4) Zinc-plated Steel Washers, 15/16" ID, ⅞" OD, .010" Thick
(2) Zinc-plated Steel Screws, Round Head, Slotted, No 8 Size, 1" Length
(2) Zinc-plated Steel Screws, Flat Head, Phillips, No 12 Size, 1-1/2" Length
(1) Zinc-plated Steel Cotter Pin, 3/16" Diameter, 1-3/4" Length

	Small 7"	Large 10"
Jaw width	7"	10"
Max Jaw Opening	9"	12"
Max extension under bench	13 7/8"	17 3/8"
Back casting height	2 1/4"
Max dog height	7/8"
Max Clamping Depth	4 1/8"
Wooden handle length	12 3/4"