The set of five bedgers tools in a box
A few weeks ago I wrote about about the actual gouges and hook tools used for mainstream turning - as opposed to the scraping tools used mostly in ornamental turning on fancy hardwoods.
In that post I mentioned that I was unaware of any current manufacturer that makes hook tools today. Since I wrote that I have found a few specialty makers that make machined, beefier versions of traditional hook tools for turning the inside of a bowl. As it happens, while I have no practical experience with hook tools, I own a set of hook tools from the late 18th century made by Salt, a company based in Birmingham, England. Some of the tools look exactly like the images in the various books, and some are shapes that I've never seen illustrated anywhere.
So far I have been unable to track down any details about Salt. I think the tools themselves are probably a set (two of them are stamped Salt, but the others have no markings on them), the case seems a later addition. All the tools show a fair amount of wear - and are not sharp enough for use. The surface finish suggests that they were pretty rusty before they became a collectible. The handles are longer than average lathe tool handles because typically people would tuck them against their body and under their arm when using. The dealer who sold these tool told me that they were 18th century bodger's, or chairmaker's, tools. I have no idea if he is correct. Until I can track down the maker, I won't know for sure. Similar tools were used by chairmakers at least until before World War II.
The three hook tools in the kit
Three of the tools are hook tools: a tight hook, a larger hook, and a third straight hook that are all right out of Moxon.
The two "gouges" in the set both have their cutting edges on the inside between the rods
The other tools look like gouges, but the cutting edges are on the inside of edge of the blade, not the outside, and the insides show extensive sharpening. The general geometry of the way the tight and larger hook tools are sharped, and in particular how they curve down from the handle, suggests that they are designed to work with the shaft of the tool on the toolrest and the cutting edge dangling below the center line of the lathe, shaving wood upwards. Green timber would turn wonderfully this way.
These tools were designed for use with a pole lathe. On a powered lathe, or even a treadle lathe, the added speed could be scary. I haven't had the courage to sharpen them up to give them a try. Maybe when I am a better turning and feel more in control I will.
This small hook tool is very elegantly bent The well worn middle size hook tool that's in the kit "Salt" of Birmingham - the maker
Join the conversation
04/15/2026 Earl
That "straight" hook is a little reminiscent of the spoon and bowl carver's "twca cam," isn't it? Any chance there is a connection between toolsets of the two greenwood trades?
Joel's Blog
Built-It Blog
Video Roundup
Classes & Events
Work Magazine